The Cheetah II RDA, with its 24mm diameter, is a bit wider than the standard 22mm but has a hight of a mere 30mm including the drip tip.
This means that you get a nice, compact set up without in any way compromising the performance.
The Cheetah II is made from 304 steel and has a fantastic wide bore Ultem drip tip with a 10mm hole.
The height of 30mm makes it a very compact vape-devil that will look good on any Mod.
The guys at OBS have really hit the mark with this RDA: It is the perfect match of huge, dense clouds and a fantastic flavour experience.
Note: When you receive the Cheetah II, the O-rings will probably be a bit dry and the RDA will, therefore, be hard to pull apart. A good trick is to put a bit of e-juice on the O-rings. The top cap of the RDA will then be easy to pull on and off.
A deck made for dual coil:
The Cheetah II is designed for dual coil builds only. The AFC is made for huge clouds.
The air is pulled in through the two large 10 x 2mm slots on the side of the tank, and are fully adjustable.
The deck of the Cheetah II has a diameter of 21mm and features four large wire holes that will allow you to use any wire size and -type you prefer.
The crosshair post screws are made from stainless steel.
The deck has PEEK insulators (PEEK is a highly heat-resistant plastic material. More info here.) and the juice well is a massive 6mm deep so you'll get a nice long vape time from a single dripping.
If you like your vape huge and flavourful and you want to treat your eyes and lips at the same time, the OBS Cheetah !! RDA truly is a safe bet!
The purchase is for:
1 x OBS Cheetah II RDA. 1 x Crosshair screwdriver.
2 x pre-spun Clapton coils
Bag with spare O-rings, post screws and a pad of cotton.
Remember to wash/clean the tank before use.
*No coil wire and only a small amount of wick is included with this product. We suggest you purchase some if you don't already have them.
This is an advanced re-buildable atomizer. There is a risk of damaging your Mod or your batteries if your coil set-up is wrong.
It is strongly recommended that you always test your coils with a multimeter/Ohm-meter before attaching the atomizer to your Mod/battery.
Coils with a low resistance (Ohm) are not suitable for all Mods/batteries. It is recommended that you make sure that your Mod/battery is able to handle low Ohm before using a low/SubOhm coil/atomizer.
*The guarantee applies to errors in manufacture only.
The OBS Cheetah II RDA in three beautiful finishes.
Scrivi una recensione
Il Tuo Nome:
La Tua Recensione:Nota: Il codice HTML non è tradotto!