Aspire - 2ml Cleito 120 Tank

Aspire Cleito 120 SubOhm Tank

If you are familiar with the Aspire Cleito tank, you will recognize a lot about the Cleito 120.

In many ways the two tanks are alike but this Cleito is designed for vaping at high Watts!

• Material: Stainless 304 steel and pyrex glass.
• 2 ml juice capacity.
• Easy top-fill.
• Re-designed high performing vertical Clapton coils of 0.16Ohm.
• Size: Diameter 25mm, height 58mm.

Aspire calls the Cleito 120 a "Maxi Watt" tank. It is designed for vaping at 100-120W.

Features:

• Made from Stainless 304 Steel and pyrex glass.
• 510 connection.
• Easy top-fill.
• 2 ml juice capacity.
• Tube made from pyrex glass.
• Comes with two replacable 0.16 Ohm coils (100-120W).
• Coils are made from Clapton wire.
• Wick is made from 100% organic cotton.
• Three-airhole AFC (Air Flow Control) is easily adjusted by twisting the AFC ring.
• Wide bore drip tip included. You can use any 510 tip.
• Dimensions: Height: 58mm Diameter: 25mm.

The Tank:

The Cleito 120 is a design based on the original Cleito tank.
It has a diameter of 25mm, an improved airflow, a re-designed top-fill and special coils made for vaping on high Watts.
The basic design is still the same, the coil is also the chimney of the tank.

Coils:

Aspire has focused on re-thinking the airflow of the tank and the coils.
As the coil is also the chimney of the tank you get a tube that leads directly from the coil wire/wick to the mouthpiece.

The Cleito 120 tank comes with two 0.16 Ohm coils. They have three large juice holes to make sure the wicks are always fully saturated with liquid.

According to Aspire the coils will perform best between 100-120W but can be used all the way up to 160W.

As always when it comes to Aspire, the coils are easy to change.

The Air Flow Control (AFC):

A good airflow is pivotal for a SubOhm tank and airflow is much more than just "all open - straight through", it's about designing where the air goes and when it goes there.

The Cleito 120 will give a large amount of air through the three large holes in the AFC.

The juice-fill:

Close the AFC, unscrew the top of the tank and drip your liquid down one of the two fill-holes.
Stop a millimetre or so before the threads, screw the top back on and re-open the AFC.
*Remember always to Prime your coil before first use.