Eleaf HW Coils
THESE COILS ALSO FITS TFV8 BABY BEAST.
Powerful coils from Eleaf, that will fit the Ello tank, but they can also be used for the TFV8 Baby Beast subohm tank.
- HW1 Single coil SS316L 0.2ohm.
- HW2 Dual coil Kanthal 0.3ohm.
- HW3 Tripple coil Kanthal 0.2ohm.
- HW4 Quad coil 0.3ohm.
- 100% organic Japanese cotton wick.
HW1 (High Watt 1) coils are made with 316L steel wire in a vertical parallel design that will not only provide a lot of vapour but also an amazingly clear taste from your e-juice.
They can be used for Wattage controlled vaping and TC (Temperature Control) if you have a Mod with SS TC Mode.
HW2, HW3 and HW4 (High Watt) coils are made with kanthal wire, that will not only provide a lot of vapour but also an amazingly clear taste from your e-juice.
They can only be used for Wattage controlled vaping as they have kanthal wires
The wick in all the HW coils is made from 100% organic Japanese cotton that will ensure an ample and stable juice flow to your coil.
When using coils with 0.3 Ohm or less, please note:
- You will need a sub ohm battery, a powerful VW Mod or a Mech Mod.
- Use batteries of at least 25Amp.
- Remember to prime your new coil before filling liquid in the tank. Drip approx. 8 drops of e-juice directly onto the wick inside the coil to make sure it is drenched in juice. Then fill the tank with juice and wait a few minutes before using the tank.
- Start at a low Watt setting (if using a VW Mod) and increase the power gradually.
The best Wattage setting for these coils are:
- HW1 SS316L 0.2ohm - 50-65 Watt.
- HW2 Kanthal 0.3ohm - 45-60 Watt.
- HW3 Kanthal 0.2ohm - 50-130 Watt.
- HW4 Kanthal 0.3ohm - 40-110 Watt.
The purchase is for:
5 PCS - Eleaf HW coils with requested Ohm.